EASYCODER 3440 DOWNLOAD DRIVER

Intermec EasyCoder 3440 Thermal Label Barcode Printer 400dpi Parallel

You will need it to set the correct media sensitivity number. The next instructions cover how easycoder 3440 load media for straight-through print mode using a roll of direct thermal or thermal transfer label media.

The default setting for the printer is direct thermal mode; use PrintSet to change the printer to thermal transfer mode. To load the easycoder 3440 1 Raise the printhead by rotating the head lift easycoder 3440 clockwise until the printhead disengages.

Intermec Ribbons – QTE Solutions

If you are using a narrow roll easycoder 3440 media, less than 7. Note: The printer does not require the use of the media support. Make sure that the edge guide slides all the way to the outer edge of the lower media guide.

Make sure the label passes between easycoder 3440 upper and lower media guides. The front edge of the media should pass over the tear bar and out the front of the printer. Your printer is now ready to print labels.

• INTERMEC s OEM Printhead for Models Easycoder //e -
• EasyCoder Printer Drivers BarTender by Seagull Scientific
• Intermec EasyCoder Thermal Label Barcode Printer dpi Parallel for sale online eBay
• 인터맥(Intermec) & 허니웰(Honeywell) - 통합드라이버, V2017.1
• Intermec Ribbons
• How to manually Factory Default a 'legacy' Intermec industrial printer

Note: Refer to the label located on the inside of the media cover for easycoder 3440 on loading media. For your convenience, you may want to refer to it when loading media in the future. Loading Media for Self-Strip Printing Use self-strip printing in applications where you want to apply labels to a surface immediately. After printing a label, the printer prints out the label with the backing removed. The rewinder hub collects the backing after it passes over easycoder 3440 self-strip assist roller. The rewinder hub can hold the backing from an entire roll of media.

For the C printer, self-strip printing is an option easycoder 3440 you order with your printer. Self-strip printing is standard on the B. To load self-strip media easycoder 3440 Raise the printhead by rotating the head lift lever clockwise until the printhead disengages.

Turn it clockwise to lock it in place. Turn the supply roll retainer clockwise to secure. Screw it easycoder 3440 place.

If you are replacing the empty media roll with a new roll of the same width, you do not need to adjust the edge guide. Turn the rewinder hub clockwise to remove all slack from easycoder 3440 media liner between the tear bar and the rewinder hub.

Grasp the leading edge of the label where it has separated from the backing and pull it away from the easycoder 3440. The printer is now ready to print labels.

Loading Thermal Transfer Ribbon Easycoder 3440 you plan to use thermal transfer mode, easycoder 3440 must install a thermal transfer ribbon TTR to print in thermal transfer mode. Note: Save the packaging that your ribbon came in. Attached to the ribbon packaging is a small label with a three-digit sensitivity number printed on it.

You need this information to set the correct media sensitivity number. If you have a easycoder 3440, the core of your thermal transfer ribbon is either made of cardboard or plastic.Intermec EasyCoder - label printer - monochrome - direct thermal / thermal transfer overview and full product specs on CNET. EasyCoder Windows printer drivers by Seagull Scientific make it easy to print labels, cards and more from any true Windows program, including our.